TRACERTOTAL CHLORINETClCODE 1740POCKETESTERä
Total Chlorine Tracer Offset Adjustment Procedure1. Obtain a sample with a known concentration of total chlorine.2. Follow the Chlorine Measurement pr
3. Pipet exactly 1.00 mL of the 100 ppm solution into a third 100 mLvolumetric flask. Dilute to the 100 mL line with deionized water. Capand mix. This
MAINTENANCEStorageWhen not in use, the TRACER should be stored dry with the electrodecap in place. Cover the connector with the clear cover whenever t
Replacing the ElectrodeThe TRACER is shipped with an electrode attached. If the electrodeneeds to be replaced or changed, follow these steps.1. Press
TROUBLESHOOTINGProblem Check ActionPower on but nodisplayBatteries Insert batteriesVerify correct polarityReplaceUnstable reading Electrode Immerse pr
ORP TRACER Electrode,±999 mV Code 1734The ORP TRACER Electrode (code1734) requiresan initial soaking in a pH 4.0 buffer solution. OrderpH 4.0 Mini Buf
LaMOTTE COMPANYHelping People Solve Analytical Challenges®PO Box 329 • Chestertown • Maryland • 21620 • USA800-344-3100 • 410-778-3100 (Outside U.S.A.
WARNING! This set contains chemicalsthat may be harmful if misused. Readcautions on individual containerscarefully. Not to be used by childrenexcept u
TRACERTOTAL CHLORINE POCKETESTERTMCODE 1740TABLE OF CONTENTSIntroduction ... 4Specifications ...
TABLE OF CONTENTS (con't)Troubleshooting ... 14Expanding Your TRACER ...15Warranty ...
SPECIFICATIONSDisplay Multifunction display with bar graphOperating conditions32 to 122°F(0to50°C) and < 80% RHChlorine range 0.01 to 10.00 ppm (To
METER DESCRIPTIONFront Panel Description1. Battery compartment2. Display3. MODE/HOLD button-store data4. CAL/RECALL button-change temperatureunits and
BASIC OPERATIONPowering the TRACERIf the batteries are weak, the BAT indicator will appear on the display.Press the ON/OFF key to turn the TRACER on o
TESTINGConditioning the ElectrodeThe TRACER electrode comes in a factory cleaned condition. If themeter is new or has been in storage for an extended
Recalling Stored ReadingsNOTE: The HOLD symbol should not be displayed. If it is, exit theHOLD function by pressing the MODE button.1. Press the CAL/R
Comments to this Manuals